Choosing insulation for your property helps you product every part of the house or building. Plus, you may need to add insulation to an older building that has a draft, is inefficient, or is not insulated according to the local building codes. Use the tips listed below to find insulation that will make your home or facility the most comfortable place to be.
Insulate The Walls
When you are insulating the building, you must start with the walls. Insulating the walls prevent air from escaping the house. You may feel a draft if you do not have insulation in the walls, and you should add insulation to the walls of any additions you make the house. The same is true in your office. Even if you are storing vehicles and work tools, you need to insulate the building to some degree. If you do not, the building will be too cold or hot to enter during extreme weather events.
Fiberglass insulation panels fit between the rafters and studs in each room. These fiberglass panels have a paper cover that is easy to cut, and you can trim each panel to the appropriate size. Plus, you can use fiberglass insulation in open areas where drywall has not been installed. The insulation will sit in place until you are ready to close up each wall.
Insulate The Pipes
Pipe insulation is the best way to make sure that your pipes are protected from extremely hot or extremely cold weather. Pipe insulation will keep hot water hot, and the insulation will keep cold water from heating even in the summer.
Plus, you need to use pipe insulation when pipes are exposed to the outside air. This form of insulation is more important when you are protecting outside spigots. Pipes can be insulated with a foam spray if you are covered a small exposed portion of the pipe. However, you can use roll insulation or wrapped fiberglass panels to protect larger pipes.
Insulate The Roof
You can use roll insulation on the roof to ensure that there is an underlayment protecting the attic. The roll insulation that you use can be unrolled easily. The thin layer that you put between the shingles and the roof boards will prevent air and water from passing through the roof. This is very important because you do not want to feel. Draft in the attic. If you have any gaps in the attic or outlet/fan mounts, the air will pass through those gaps into each room.
Insulate The Attic
You must insulate the attic with either loose insulation or panels that are cut to the proper width. These panels are easy to unfurl in the attic because they can cover a long distance from one side of the house to the other. If you want to put loose insulation over these panels, you can increase your protection.
You may need to spray foam insulation into the gaps that are created by fan mounts and lights. Plus, you should look for the small gaps around vents and air ducts. When you have covered all these areas, you will prevent a draft from Blowing through the house.
Insulate Exterior Gaps
Your home has exterior gaps near spigots, outdoor outlets, and roof vents. The dryer vent on the side of the house should be insulated and you may need to place a flap over the vent so that air does not come back through the vent tunnel to the laundry room. You may have exterior outlets that need to be insulated with foam insulation, and there are times when pipes enter the house through an uninsulated gap.
Conclusion
The insulation that you have chosen for the house makes the space more efficient and more comfortable. You may ask a professional installer to help you with these products, and you can install more insulation around your home if you have found extra gaps. You may need to use the insulation when you feel a draft, or you could put insulation in the walls of new rooms that have been added to the house. You can insulate your pipes to prevent pipe breaks, and you can insulate exterior gaps that might allow water or air to enter the house.
